New Frames for the Whirlwind Fighter...

Read the forum code of contact

Member for

10 years

Posts: 70

[ATTACH=CONFIG]237284[/ATTACH][ATTACH=CONFIG]237285[/ATTACH][ATTACH=CONFIG]237286[/ATTACH];)

Attachments
Original post

Member for

20 years 6 months

Posts: 7,025

:applause: Well done,please keep updating :)

Member for

17 years 10 months

Posts: 3,778

Very nice work, well done and I look forward to more updates.

Member for

16 years 4 months

Posts: 2,094

Well done everybody!

Member for

12 years

Posts: 1,141

When doing this, do you make more than one??
Not being an engineer etc
And documentation, and is this built better, or to the same standards ??
An inquisitive Duggy

Member for

10 years

Posts: 70

When doing this, do you make more than one??
Not being an engineer etc
And documentation, and is this built better, or to the same standards ??
An inquisitive Duggy

We are building to the same standard but in some cases the build will be better as we can take our time over it.

Member for

10 years

Posts: 70

When doing this, do you make more than one??
Not being an engineer etc
And documentation, and is this built better, or to the same standards ??
An inquisitive Duggy

And because of cost we only make one of each.

Member for

10 years

Posts: 70

[ATTACH=CONFIG]237332[/ATTACH][ATTACH=CONFIG]237333[/ATTACH]

Very nice work, well done and I look forward to more updates.

A few more pics

Attachments

Member for

11 years 2 months

Posts: 901

I will be at the workshop tomorrow, so fingers crossed we can do some more.

Member for

14 years 5 months

Posts: 3,447

Hi.. if you get this in time.. the rear fuse skin plank full size unfolded drawings will be with you Tuesdayish, probably. Hope there's still stuff to do in the meantime without them. Did you see my email about R-67544?

Great work!

Matt